Stealth™ Recoil Spring - SRS™- AR15-KIT (C, H, H2) GEN4
The Stealth Recoil Spring™ SRS™ GEN4 is a self-contained multi-stage drop-in replacement for your standard buffer and spring. The SRS™ is designed to keep the buffer spring from rubbing against the inner wall of the buffer tube providing smooth, quiet operation and the second stage helps reduce the felt recoil significantly.
The AR15 KIT comes assembled as a C and includes an H and H2 weight so you can tune it the way you need it.
NOTE: The new GEN4 version does not have the oring on the weight.
To eliminate any potential failure points we changed the screw to a roll pin across the plastic end piece and the cap is machined on the rodm replaced the snap ring with a washer.
Availability: In stock
FEATURES: Drop-in replacement for standard buffer and spring Reduce felt recoil Keep the buffer spring from rubbing against the inner wall of the buffer tube Buffer mass is designed to stay under constant tension against the bolt carrier Made in the U.S.A. SPECIFICATIONS: Length: 7.18"Equivalent Weight: C: 3.3 oz. H: 3.8 oz. H2: 4.7 oz.Actual Wight - Complete System (new version with stainless steel weight): C: 6.2 oz. H: 6.6 oz. H2: 7.4 oz.COMPATIBILITY: AR-15 with carbine-length buffer tubeMost bolt carriers have a rear opening of over .60″, there are a couple of bolt carriers in the market place that have a rear opening of under .60″ and will not function with the SRS.INSTALLATION AND MAINTENANCE:Before installing the recoil spring, it is always a good idea to retighten the screws using either using two 3/32 hex key and fully tightening both screws at the same time or using one 3/32 hex key and using the hole in the rod for leverage.The polymer bumper goes towards the rear of the firearm and the weight mass goes towards the bolt carrier.The SRS can be installed with our without the buffer retainer. Most people run the SRS without the buffer retainer for ease of maintenance.
Write Your Own Review